Is it true that very lightly sanding the edge of the topsheet will help stop damage to it?? any other tips out there??
Announcement
Collapse
No announcement yet.
how To: Stop Top Sheet damage??
Collapse
X
-
I round the top edge using a fine tooth file, multiple passes, and a light touch. I find that it is easier to control and there is less chance of scratching the top surface than with the sand paper.sigpic
Osprey, Sherpa, Custom Coda 120WT, Custom DS110, Condor (Green), Spliff
Custom Twist Out duck foot bindings, Bombers (custom duck foot base plate and 3 pads), releasable S810ti on custom duck foot riser
Nordica N3 NXT ski boots (best so far)
Wife: 104 SII & 100 Blunt XL with S810ti bindings on custom "adjustable duck foot" risers
Loaners: 125LE, 105 EMP, 101 KTP, 100 Blunt XL, 98 Slapdash, 88 Blunts
Comment
-
Originally posted by ///M3Matt
after each day I use very fine sandpaper to smooth out any nicks.....i might also put some super glue on any chips
tedious but worth it
To be honest, I don't think there would be much difference except the Sglue sets much faster. Easier for small nicks.
Worked nice (except for filling one big gash), so if it's a big'un I'd recommend epoxy.
James"And above all remember to have fun"
Comment
-
Its not for the surface donut. Just to wear the edges smooth, so they are less likely to catch on ice etc. I Find the majority of scratches happen in line....
Boards:
Spruce 120s(x2), ALPs(x3), Lacroix 99's, BWPs.
Bindings:
Pro Prime Riser/Rossi Bindings(x2).
Comment
-
If you are up for a project requiring a little effort, you can reduce the amount of topsheet chipping on sidewall boards a lot by filing a vertical sidewall onto the board and then rounding off the edge of the topsheet as described elsewhere in this thread. The attached sketch shows the cross section of a Rossignol "Scratch" twintip ski. Notice how the bottom 3mm or so of the sidewall is exactly vertical and the sidewall above the vertical section "leans in". On most sidewall boards, the sidewall comes from the factory with just the "lean in" and no vertical section on the sidewall. If you take a good quality flat file and file the edge of the board until you get 2 to 3 millimeters of vertical sidewall at the bottom of the sidewall, the amount of topsheet chipping will go down, usually a lot. In addition, if you do the filing carefully you will end up with nice sharp edges.Last edited by Greco; 01-30-2009, 08:25 PM.
Comment
Comment