If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I think people have tried direct mounting dynafit bindings to skiboards in the past (i.e. screwing directly into the boards, like you would with regular skis)
I haven't done it personally, but I believe this creates two problems:
> Skiboards flex a lot. With direct mounted bindings, you either lose the flex (not ideal), or get unwanted pre-release (really not ideal).
> Skiboards tend to be pretty wide, and need a riser to carve nicely.
My attempt at a tech-pin setup for Skiboards is HERE in the 'Skiboarding Gear' Section. I'm going a bit weirder, and also trying to use softboots - but the basic tech-pin mount would work just as well with dynafit boots, if they were made to the correct length.
Comment